Bend Sequence: Why the Order of Sheet Metal Bends Matters
The bend sequence decides whether each flange still fits the brake. Why a wrong order makes a part impossible and how to design so a working order exists.
Ken from Sheet Metal is Fun built a whole episode around a question most first-time sheet metal designers never ask: why does the order of each bend matter? The bend sequence decides whether the next flange can even get into the machine.
Why Does Bend Sequence Matter in Sheet Metal?
Because every bend changes the shape you have to fit into the machine for the next one. Pick the wrong order and a finished flange runs into the tooling, and the part can't be finished even though the flat pattern is right.
In Why Bending Sequence Matters, Ken shows it on 26 gauge galvanized in a box brake. He bends a 3/4 in flange, then tries a 1/2 in flange next to it, and the first flange runs into the brake finger. Swap to a 1/2 in flange followed by a 1 in flange and there's room to spare. He also bends a blank in the wrong order on purpose, and after that first bend the other two become, in his words, "impossible or very improbable and even impractical."
His rule for planning is simple. The first bend is the one that changes the piece the least, which on his panel is a cross break to stop oil canning. Hems come next, then the 90s. He numbers every bend on the blank and works backward from the finished part. One more detail: the second bend opened his first one slightly, and he had to push it back.
The Same Problem on a Press Brake
A press brake has the same problem at a bigger scale. David Bishop's article 9 strategies for preventing part collisions on the press brake says the most common collision is the part hitting the punch, often on long return flanges or a complicated bending order. Deep U-shaped parts tend to hit the ram. On boxes, the sides sweep up toward the ram or clamps on the third and fourth bends, and he gives a rule of thumb of punch height at about 1.7 times the box depth. His fix for the planning side is to simulate the bends before the part reaches the brake.
Designing So a Working Order Exists
Most sequence problems start in CAD, usually with a short return flange or a deep, narrow channel. Our posts on narrow U-channel bends and the minimum distance between parallel bend lines cover the geometry. Order also affects which edge gauges the next bend, which feeds the stack-up described in tolerances on a part that's laser cut and bent.
What We'd Do on Your Part
Our sheet metal quote simulates the bend sequence and flags collisions. If no bend order can produce the geometry, the part is marked as not bendable and can't be ordered until it's corrected, which is a lot cheaper than finding out at the brake.
Need a part made?
Upload your file for an instant price.