← All posts

Built-Up Edge: Why Metal Welds Itself to the Cutter

Built-up edge is chip material welded to the cutting edge, and it ruins finish and size. Which metals do it, how to spot it, and why more speed helps.

Harvey Performance's Don Grandt opens an In The Loupe TV episode with two questions buyers and new machinists both ask: what is built-up edge, and how do you stop it? If your aluminum or stainless parts come back with a torn finish or a size that wanders over a run, BUE is one of the first suspects.

What Is Built-Up Edge and How Do You Stop It?

Built-up edge is workpiece material that pressure-welds itself to the cutting edge and starts acting as a new, badly shaped edge. You stop it with sharp, material-specific tooling that has a slick flute finish, and often by raising the surface speed instead of lowering it.

In the episode, Grandt names the usual offenders as the gummy, ductile stuff: 6000-series aluminum, copper, 304 stainless, 1018 and other low and medium carbon steels, plus titanium and nickel alloys that aren't hardened. That covers a good chunk of a normal job shop's week.

Why It Hides

His most useful point is that the problem disguises itself. The welded lump keeps growing until it flakes off, and when it goes it takes part of the edge with it. Pull that tool at end of life and it looks chipped, so you blame the feed or the setup. His fix is boring and it works. Run five minutes, pull the tool and look at it, then check again every 5 to 10 minutes until you know whether material is sticking.

Harvey's write-up on built-up edge in turning explains why the part suffers. The welded material changes the edge geometry and where the cutting edge actually sits, and that shows up as poor finish and size variation. It also says BUE is often visible without a loupe, as material stuck to the rake or flank face.

Faster, Not Slower

The counterintuitive part is speed. Grandt says the trouble zone is the middle of the surface footage range. Bump the speed up and the chip gets hot enough to soften and slide off the edge instead of sticking. He shows it with a cold butter knife that comes out coated and a heated one that comes out clean. Rubbing is the other cause, so take a real chip instead of a light skim, and keep coolant concentration where it belongs. Our posts on copper C110 and running aluminum dry or with coolant cover two of the stickiest cases.

What It Means for Your Part

You won't see BUE on a drawing, but you'll see it in the finish and in bores that drift. Aluminum 6061, Stainless 304, Mild Steel 1018, Copper C110 and Titanium Grade 5 are all on our Materials page, and any of them can build an edge if the tool or speed is wrong. If a surface finish or a tight bore matters, put it on the drawing, and ask us when you quote how we'd tool that material. Work hardening in 304 is the close cousin worth reading next.

Need a part made?

Upload your file for an instant price.

Start a quote