← All posts

Deep Hole Drilling: How Deep Can a Drilled Hole Go?

Deep hole drilling is about depth-to-diameter ratio. How far a twist drill goes with pecking, why chips limit it, and how to design holes around it.

A 6 mm hole 150 mm deep is one line in CAD. On the machine it's 25 diameters of chips packed into two flutes, and somewhere well before that depth you're into deep hole drilling.

What Counts as a Deep Hole, and How Deep Can a Normal Drill Go?

It's set by the ratio of depth to diameter, not by depth alone. A standard twist drill handles a few diameters easily, pecking takes it further, and past roughly 10 diameters you're into special drills or dedicated deep hole processes.

UNISIG, which builds gundrilling and BTA machines, answers the question in What is Deep Hole Drilling? What Is Gundrilling?. Its description says a deep hole "is defined by its depth-to-diameter ratio (D:d), and typically holes greater than 10:1 are considered deep holes," and traces the process back to the need for straighter, more accurate gun barrels.

Tooling people draw the line earlier. CNCCookbook's drilling guide says most tool makers treat anything past 3 or 4 diameters as deep. It gives a rough ladder for twist drills: 5 diameters without issue, peck drilling from 5 to 7, a parabolic flute drill with pecking from 7 to 10, and a dedicated deep hole technique beyond that. That's one source's rule of thumb, and material changes it.

Why Deep Hole Drilling Gets Hard

Chips. The deeper you go, the farther they have to climb the flutes and the harder it is to get coolant to the tip. Pecking backs the drill out to clear them, which works but adds time on every hole. Through-spindle coolant helps a lot here; when through-tool coolant actually changes tool life gets into when it's worth it.

Straightness is the other problem. A long, skinny drill can walk, so the exit lands off the entry even when the diameter measures fine. That's the gun-barrel problem the dedicated machines were built for.

Design Moves That Keep You Out of Deep Territory

First ask if the hole needs to be that small. A lot of deep holes are clearance or fluid passages that could be bigger. Same 60 mm depth, going from 4 mm to 6 mm drops the ratio from 15:1 to 10:1.

A through hole can often be drilled from both ends so each side only goes halfway. You'll get a small mismatch where they meet, so don't do it on a bore that has to be straight end to end.

Blind tapped holes follow their own rules, covered in how deep to drill a blind tapped hole. And if the deep hole needs a precise finished size, reaming vs boring matters more than the drill.

Our CNC page covers 3-, 4- and 5-axis milling and turning, and gundrilling isn't on it. For a hole past roughly 10 diameters, ask us when you quote.

Need a part made?

Upload your file for an instant price.

Start a quote