← All posts

Joggle Bend in Sheet Metal: Offset Design Rules

A joggle bend in sheet metal steps a flange over by about one thickness. When two plain bends work, when it takes offset tooling, and how to dimension it.

A joggle is the little step that lets one panel lap over another and sit flush. A joggle bend in sheet metal looks simple on the model, but those two bends sit very close together, and that decides how a shop can form it.

Can You Form a Joggle With Standard Press Brake Tooling?

Sometimes. If the offset is tall enough, two normal bends with a flip in between will do it. When the bends are too close for the die, it takes offset tooling that forms both bends in one stroke.

Wilson Tool asks a version of this in Air Bending with Offset Tools: "Did you know you can use standard offset tools to air bend?" Their point is that when the customer needs a set offset height and the angle can vary, "you may not need to invest in a custom tool."

Why Joggle Bends Get Tricky

Two opposing bends need room. With standard tooling, the first bend has to sit across the die while the second one forms, and a short step won't span it. The Fabricator's strategies for forming offsets says "Many offset bends are too close together for standard press brake tooling," and describes horizontal offset tools built to step the material "by one material thickness."

That's the classic lap joggle: one thickness of offset so the mating sheet sits flush.

Designing a Joggle Bend in Sheet Metal

  • Dimension the offset clearly. Say whether the height is outside to outside or inside to inside. See inside vs outside dimensions.
  • Keep holes off the joggle. Anything inside the bend zone tends to distort, as in how close a hole can be to a bend.
  • Say which matters, the height or the angles. If the angles can float, a standard offset tool may hit your height.
  • Make the web between bends as long as the design allows.

What Happens When You Quote

Our sheet metal analysis reads the bend count, bend angles and inner radii from the model and validates the bends. A joggle shows up as two bends. Note the joggle and its step height on the RFQ, and ask us when you quote whether the offset needs a design change. Our bend angle tolerance is ±0.5°, and on a joggle the two angles together set the step height, so call out the height if it's what matters.

The materials are the usual sheet list: Cold Rolled Steel, Galvanized Steel, Aluminum 5052, Aluminum 6061, Stainless 304 and Stainless 316.

Need a part made?

Upload your file for an instant price.

Start a quote