Least Material Condition: When LMC Beats MMC
Least material condition protects the wall around a hole, not the fit. How the LMC modifier works, a worked edge-distance example, and when to use it.
Vision Tech Engineering's GD&T lesson lists the question right in its description: what is LMC in GD&T? Least material condition is the size limit where a feature holds the least metal, and as a modifier it guards walls and edges rather than fits.
What Is Least Material Condition (LMC) in GD&T?
Least material condition is the size at which a feature has the least material: a hole at its largest allowed diameter, or a shaft at its smallest. Put the circled L on a position tolerance and the stated tolerance applies at that size, with bonus tolerance added as the feature moves toward MMC.
In GD&T LMC Condition Explained, the presenter first tries LMC on a shaft and shows why it backfires for assembly. The fatter the shaft gets, the more position error LMC allows, which is backwards for a fit. Then he uses it where it belongs.
A hole sits near the edge of a block at 20 mm plus or minus 1 mm, with a 0.5 mm position tolerance, and the wall to the edge must never drop below 2 mm. The basic dimension from datum A works out to 2 + 10.5 + 0.25 = 12.75 mm. At 21 mm, the LMC size, the hole gets 0.5 mm of position tolerance. At 20 mm it gets 1.5 mm, and at 19 mm it gets 2.5 mm. Run the worst case at either end and the wall still comes out at 2 mm.
Least Material Condition vs MMC
MMC protects assembly, since a hole at its smallest is the worst case for a bolt to pass. LMC protects what's left around the feature. GD&T Basics shows the difference on a flywheel with eight weight-reduction holes in Can Minimum Wall Thickness be Ensured When Using the MMC Modifier?. With LMC, the holes get .010 of position at 1.755 and pick up bonus as they shrink. Swap in MMC and the biggest holes get the most position tolerance, so the minimum wall is no longer guaranteed. Their conclusion is blunt: to hold a minimum wall, call LMC.
Our MMC bonus tolerance post covers the assembly side, and plus/minus vs position tolerance covers why position beats coordinate tolerances for hole patterns.
When to Use It
Reach for LMC when a feature's job is to leave metal behind, like a bore close to an outside wall or a hole near a thin edge. If the same feature also has to assemble with something, one modifier won't cover both, so work the worst case for each before you pick. Our post on how thin a wall can be helps you set that minimum in the first place.
On Your Part
Our CNC page lists ISO 2768-m as standard, down to ±0.01 mm where the drawing calls for it, and the quote checks for thin walls. LMC bonus has to be worked out from the measured hole size, so if you need it reported on inspection, ask us when you quote.
Need a part made?
Upload your file for an instant price.