← All posts

NPT vs BSP Threads: Which Pipe Port Goes on the Part?

NPT vs BSP threads look close enough to start, then leak. How the 60 and 55 degree forms differ, and why taper vs parallel decides where the seal sits.

A manifold drawn in the US and plumbed in Europe is a classic way to find out about NPT vs BSP the hard way. The fitting threads in a turn or two and then weeps the moment it sees pressure.

What Are the Differences Between BSP and NPT Threaded Fittings?

The thread form. NPT is cut at 60 degrees with flat crests and roots, and BSP is cut at 55 degrees with rounded ones. The pitch is close in some sizes, which is exactly why people get them mixed up, but the two don't seal together.

The Metal Company answers that question in Differences Between BSP Threaded Fittings and NPT Threaded Fittings?. BSP comes from Britain and NPT from the US. Their tip for telling them apart on the bench is to feel the crests. NPT feels sharp, BSP feels rounded, and if that's not conclusive, count threads per inch and check a table.

NPT vs BSP Is Really Taper vs Parallel

BSP comes in two flavors, and that's where drawings go wrong. Swagelok's Basic Pipe Threads Explained lays it out. NPT and BSPT (ISO 7/1) are both tapered at 1° 47' and seal by interference on the thread flanks, so they always need a sealant. BSPP (ISO 228/1) is parallel. It doesn't seal on the threads at all, and the seal comes from an O-ring or gasket against the port face, with no tape.

Swagelok also says outright that ISO and NPT tapered threads shouldn't be intermixed, since the angle differs and in many sizes the threads per inch differ too. A tapered seal, per the same article, happens between the third and fifth thread, so a sloppy start shows up as a leak, not a loose fit.

What to Put on the Drawing

Write the standard, not just a size. "1/4 pipe" means nothing to a shop that runs both. A callout like 1/4-18 NPT, or the BSPP equivalent with its sealing face shown, leaves no room to guess. For a parallel port, the flat spotface the gasket sits on is part of the seal, so dimension its diameter and finish like you would an O-ring groove.

Tapered ports can be cut with a pipe tap or thread milled, and thread milling vs tapping covers why a shop might pick one or the other. Don't borrow a 2B or 3B class for a pipe thread either. Those classes belong to straight unified threads.

Our CNC quote picks up threads as detected features in Aluminum 6061, Brass C360 and the rest of the stock list. Pipe ports aren't called out on the CNC page, so for tapered or parallel pipe ports and how we'd gauge them, ask us when you quote.

Need a part made?

Upload your file for an instant price.

Start a quote