← All posts

Powder Refresh Rate: Does Reused SLS Powder Hurt Parts?

Powder refresh rate is the minimum share of fresh powder in each SLS or MJF build. What the ratio protects, how packing density ties in, and when to ask.

Formlabs opens its video on powder refresh rate with a promise to explain what refresh rate is and what it means for your print. For a buyer, the question underneath is whether a nylon part printed partly from recycled powder is as good as one printed from fresh.

What Is Powder Refresh Rate in SLS Printing?

It's the minimum share of fresh powder that has to be mixed into recycled powder for the next build to keep the material's mechanical properties. Formlabs puts its own Nylon 12 at 30%, so a build can run on up to 70% recycled powder.

That figure comes from SLS 3D Printing Powder Refresh Rate Explained. Formlabs also says a lower refresh rate means less waste, and that you can always run more fresh powder than the minimum. For the best material properties you might go all fresh.

How Packing Density Ties In

A Formlabs reseller, MLC CAD Systems, fills in the economics in SLS Packing Density and Refresh Rate Explained. Packing density is the share of the chamber that ends up as fused parts. Their target is at least 30% so the powder you use up roughly matches the fresh powder you add. A build with one big, mostly hollow part leaves a pile of used powder that can turn into waste, and that cost lands on the parts. Parts can sit about 1 mm apart, which helps raise density. They also mention prototype builds run on low or no refresh, with a slight drop in part quality that's fine for fit checks.

MJF works on the same principle, though HP frames it as reusability. HP's materials page lists its PA 12 enabled by Evonik at up to 80% powder reusability, and other powders lower. These are each vendor's numbers for its own materials, not a universal rule.

What It Means for Your Part

A part printed at the vendor's refresh ratio is a normal production part. The ratio exists so recycled powder doesn't drag the properties down. Where it matters is qualification work, where you might want fresh powder or a record of the mix.

Packing also explains some pricing. See our posts on support-free 3D printing and what drives the price and hollow MJF parts. For choosing a process, read what's different between MJF and SLS.

What We'd Do on Your Part

Our 3D printing runs industrial SLS and HP Multi Jet Fusion, with a processing station for unpacking builds and recycling powder, and the price includes a packing factor. Refresh ratios aren't published on the site, so if you need fresh-only powder or build records, ask us when you quote.

Need a part made?

Upload your file for an instant price.

Start a quote