← All posts

Rockwell Hardness on a Drawing: Why You Call a Range

Rockwell hardness is read from indent depth, and harder steel is more brittle. Why a drawing should call a range on the right scale, and where to test.

Knife buyers have been arguing about HRC numbers for years, and the argument carries over neatly to machined steel parts. A Rockwell hardness note on a drawing only helps if it's a range on a named scale, with a sensible place to test.

What Is Rockwell Hardness, and Does It Even Matter?

Rockwell hardness is a number read from how deep an indenter sinks under a heavy load, measured from a zero set by a light preload. It matters because hardness trades against brittleness, so the right number is a range for the job, not "as hard as possible."

The question comes straight from Metal Complex's video HRC Controversy - What Is Rockwell Hardness? Does it Even Matter?. The creator says up front he's a knife reviewer, not a metallurgist. His story is about premium knife steels that underperformed in cut tests and then tested low on HRC. His main point applies well beyond knives: as you raise hardness, the steel holds an edge longer but gets more brittle and more likely to chip, so "it's not so much hard or soft, it's an optimal range."

How the Rockwell Hardness Test Works

The Wikipedia article on the Rockwell hardness test describes the cycle. A minor load sets zero, the major load goes on and comes off, and the remaining depth gives the number. Each scale uses a different load and indenter. HRC uses a diamond cone at 150 kgf for steel, titanium and other hard materials, while HRB uses a 1/16 in ball for soft steels and aluminum. A number without its scale letter means nothing.

Two practical limits from the same article matter on a drawing. The test piece should be at least 10 times thicker than the indent is deep, and readings should come off a flat surface square to the indenter, because convex surfaces read low. A thin flange or a small shaft can give you a wrong answer on a good part.

Writing the Callout

Give a range with the scale, such as a band of HRC points, and say where to test: a flat face, away from threads, ideally one that gets machined off or doesn't matter cosmetically. If the part is heat treated after machining, plan the stock as in our post on heat treat before or after CNC. If a prehardened bar can meet your range, 4140 annealed vs prehard may save a step. And if the part doesn't need hardness at all, check 4140 vs 1018.

What We'd Do on Your Part

Alloy Steel 4140 and Titanium Grade 5 are on our Materials list. Heat treatment and hardness testing aren't covered on the site, so if your drawing carries a hardness callout, ask us when you quote.

Need a part made?

Upload your file for an instant price.

Start a quote