← All posts

Rotary Broaching: How Blind Hex Sockets Get Made

Rotary broaching cuts a hex socket with a broach tilted 1 degree, one edge at a time. The pilot hole and chip room rules that belong on your drawing.

A hex socket in the end of a turned part looks simple on the drawing. Making one with sharp flats in a blind hole is where rotary broaching earns its place, and the design rules around it are easy to miss if you've never watched one run.

How Does a Rotary Broach Work and How Do You Use It?

A rotary broach is a form tool, hex or spline shaped, held at a 1 degree tilt, so only one edge of the form is cutting at any instant. As the part or tool spins and the broach feeds in, that contact point walks around the profile and shaves the shape down into a pre-drilled hole.

That's the explanation McCoskey Precision gives in How Does a Rotary Broach Work and How Do You Use It?. The video starts with a straight push broach for a keyway, where a long tool with staggered teeth takes a little more on each tooth. Push a full hex form straight in and the force would be far too high. The 1 degree tilt is the trick: it turns one big shearing job into a scraping action along one edge at a time.

Rotary Broaching Rules That Change Your Design

The pilot hole comes first. The video says to drill it about the size of the hex across the flats, or a touch bigger, and to put a chamfer at the mouth so the broach starts clean.

Chips are the bigger issue. A rotary broach pushes material down rather than lifting it out, so in a blind hole the chips pile up at the bottom. Drill the pilot deeper than the broached depth, then clean it out with the drill afterward if needed. American Machinist puts the practical depth limit for an internal form at about 1 to 1.5 times the form's diameter, because of those packed chips, and notes most fastener makers just leave the curled chip in the hole.

On the drawing, call the full-form hex depth you actually need and leave room below it for a deeper drilled pilot. A deep hex at the bottom of a short blind bore with no chip room is the one to avoid.

If the socket has to go deeper than a broach can reach, other routes exist. A through hex can go on a wire EDM, as in wire EDM for sharp corners, and a blind keyway in a bore runs into the same chip and reach problems. The same depth logic shows up in tap drill depth for blind threads.

What We'd Do on Your Part

Our CNC cell includes a dual-spindle lathe with live tooling and a Sodick wire EDM, and our quote flags hole depth-to-diameter ratio automatically. Rotary broaching isn't listed on the CNC page, so if your part needs a broached hex or spline, ask us when you quote.

Need a part made?

Upload your file for an instant price.

Start a quote