Blind Rivet Grip Range: Picking Length and Hole Size
Blind rivet grip range sets the right rivet length for a sheet metal stack. How to read a grip chart, size the hole, and why the 1.5D rule runs long.
Humble Ideas asks it in the title: do you know how to choose the correct rivet length? Most people grab whatever's in the drawer. On a sheet metal assembly the real answer is the blind rivet grip range, plus the hole size that goes with it.
How Do You Choose the Correct Rivet Length?
Add up the total thickness of everything being clamped, then pick the rivet whose grip range contains that number. The length comes with the grip range, so you don't pick it separately.
In Do You Know How To Choose Correct Rivet Length?, the rule of thumb is job thickness plus 1.5 times the rivet diameter. Their example is an 8.3 mm stack that calls for a 15.5 mm rivet, and it holds fine. They also show what a rivet that's too long does: the mandrel sticks, and you pull it out and start over. Ace Hardware's How To Choose A Rivet gives the shop-counter version. The rivet has to extend past both pieces, and you drill a hole to match the rivet diameter.
Reading a Blind Rivet Grip Range Chart
The rule of thumb gets you close. The maker's chart gets you right. Fastener Mart's blind rivet guide puts a 1/8 in rivet in a 0.129 to 0.133 in hole, which is a #30 drill. Its grip ranges come in steps, so a #43 covers 0.126 to 0.187 in and a #44 covers 0.188 to 0.250 in. In that chart the first digit is the diameter in 32nds and the rest is the maximum grip in 16ths.
Run an example. Two sheets of 0.060 in aluminum make a 0.120 in stack, inside the #42 range of 0.063 to 0.125 in. The 1.5D rule asks for about 0.31 in of length, which matches the #43 at 0.313 in, one step long. Fastener Mart's warning cuts both ways: under the minimum grip the joint stays loose, and over the maximum the rivet may not set right. Count any backup washer in the stack.
Designing the Holes
Grip only works if the hole is in the right place. Keep rivets back from edges, as covered in fastener edge distance. Match the rivet to the sheet where you can, because an aluminum rivet in stainless sheet is the same pairing as in our galvanic corrosion post. If you need a thread rather than a permanent joint, compare rivet nuts and PEM nuts.
On Your Part
Our sheet metal page lists laser cutting, press-brake forming and PEM insertion in stock sheet such as Aluminum 5052 and Cold Rolled Steel, with a ±0.13 mm cut tolerance. That's a spread of about 0.010 in, wider than the 0.004 in band for a #30 rivet hole. Model the hole at the rivet maker's size, and if it has to land inside that band, ask us when you quote whether to cut or drill it. Rivet setting isn't listed on the page, so plan to set them yourself or ask.
Need a part made?
Upload your file for an instant price.