Flatness vs Parallelism: Which Callout Do You Need?
Flatness vs parallelism: flatness controls a face's form on its own, parallelism holds it to a datum. When a drawing needs both, and how to stack them.
A QC tech looks at a drawing with two flatness callouts and asks for parallelism too. Sometimes they're right. Flatness vs parallelism comes down to one question: does the face have to sit at a set orientation to something else?
Do I Need a Parallelism Tolerance on Top of Flatness?
Only if the face's orientation to a datum matters. Flatness controls the form of a surface by itself and never references a datum, while parallelism holds the surface parallel to a datum and caps its flatness at the same value along the way.
That's the answer GD&T Basics gives in Flatness or Parallelism. The submitted question came from a designer with a sheet metal spinning: two faces called out at .020 flatness, and QC techs who thought parallelism belonged there too. The presenter points out that datum A was on the drawing, but no callout referenced it. Flatness, he says, has nothing to do with datums.
What Flatness vs Parallelism Actually Controls
His table example makes it stick. A badly built table can still have a very flat top. Whether that top is parallel to the floor is a different question, and only parallelism answers it.
The tolerance zones show why. A .020 flatness zone is two planes .020 apart that can tilt any way the surface likes. A .020 parallelism zone to A is the same width, but it's locked parallel to datum A, so a tilted face fails even if it's dead flat. Neither one locates the surface. The GD&T Basics parallelism page says it outright: parallelism does not control location.
Using Both on One Face
Parallelism already limits form error to its own value. If a face needs to be flatter than it needs to be parallel, stack a tighter flatness under the parallelism. The video's example is parallelism of .020 to A with flatness refined to .005, which keeps orientation loose and form tight. That's usually the answer to the QC tech, too.
Inspection is cheap either way. GD&T Basics calls surface parallelism one of the quickest manual GD&T checks. Set the datum face on the granite and sweep an indicator across the controlled surface. The total indicator reading is the error. That only means something if the datum is a face the part actually seats on, which choosing datums gets into. Flatness's line-by-line cousin is covered in straightness vs flatness. On plate parts, read why 6061-T651 plate still moves before tightening either number.
Our CNC work defaults to ISO 2768-m, down to ±0.01 mm where the drawing calls for it. If you need flatness or parallelism measured and reported on specific faces, ask us when you quote.
Need a part made?
Upload your file for an instant price.