← All posts

DMLS Support Structures: Why Metal Prints Need Them

DMLS support structures anchor a metal print and pull heat out of overhangs, even in a powder bed. Why metal needs them and how to design fewer of them.

If you've ordered SLS or MJF nylon, you know the powder holds the part up and nothing needs supporting. Metal powder bed printing looks the same from the outside, so DMLS support structures catch a lot of designers off guard.

If the Part Sits in Powder, Why Does DMLS Need Supports?

Because the metal melts and shrinks as it cools. Supports anchor the part to the build plate so fresh layers can't pull it into a curl, and they carry heat away from areas that would otherwise overheat.

Tri-Tech 3D's Basic rules of Metal 3D Printing raises exactly that assumption: you might think a part "completely surrounded by powder" is "fully supported everywhere." It isn't. Each new layer is fully molten while the layers under it have already cooled, so the top keeps shrinking against the bottom. Without an anchor it warps and lifts. The video also says supports should be "the last resort," because they cost material and have to be removed by hand afterward.

Overhangs and Bridges in Metal

An overhang has less solid metal under it to resist that pull and less mass to soak up heat, so it can curl or overheat. The video treats a 45 degree angle as generally safe. The Protolabs Network (formerly Hubs) metal 3D printing guide lists 50 degrees as the DMLS/SLM limit and says support is "always required" to fight warping, removed by hand or by CNC machining.

Bridges are where polymer habits fail. A flat span between two pillars has to be fully supported in metal, so there's no point keeping it perfectly horizontal. Reorient the part, or put a slope or a chamfer under the edge instead. The same guide suggests a teardrop shape for holes that run sideways and a 45 degree chamfer under unsupported edges.

Designing Fewer DMLS Support Structures

Decide the build orientation while you model, not after. Shallow out steep overhangs with a bit more material underneath, or flip the part so the worst face points up. Remember that supports sitting inside a hole or channel have to come out too. The video's minimums are 0.5 mm for freestanding walls and about 2 mm for through holes that need to hold size. Anything critical can be drilled or reamed afterward.

Our DMLS in Inconel 718 post covers when a printed superalloy pays for itself, and when DMLS beats CNC is worth reading before you commit. Compare that with support-free printing in nylon, where the price logic is different.

Quoting a Metal Print With Us

Our 3D printing page lists five DMLS alloys, from DMLS Aluminium AlSi10Mg to DMLS Inconel 718, held to ±0.3 mm or ±0.3%, whichever is greater. Printed metal parts go through a barrel tumbler to break edges. If a support scar lands on a sealing face or a fit, ask us when you quote.

Need a part made?

Upload your file for an instant price.

Start a quote