Angle Tolerance vs Angularity: Which Callout to Use
Angle tolerance vs angularity: a plus/minus angle gives a wedge-shaped zone, angularity a fixed-width band. Which keeps an inclined mating face in spec.
A chamfered seat or an inclined mating face usually gets a plain angle on the drawing, something like 60° ±2°. The angle tolerance vs angularity choice decides whether that face actually mates with its partner.
Angle ± Tolerance or Angularity: What's the Difference?
A plus/minus angle allows a wedge-shaped zone that widens the farther you get from the vertex. Angularity uses a basic angle and a zone between two parallel planes, a fixed width in mm, so the face is held to the same band along its whole length.
That's the comparison in ACCURATE ASME ISO's Angle vs Angularity Application. The example is two parts that sit on a common datum surface with inclined faces meant to match. Both get 60° ±2°. One part can come out at the plus limit and the other at the minus limit, and either way there's a gap between the faces. Adding a flatness callout makes the faces flatter but leaves the ±2° wedge untouched.
Why Angle Tolerance vs Angularity Matters on Longer Faces
Run the numbers on the video's ±2°. Over a 50 mm face, 2° works out to about 1.7 mm of swing at the far end, in either direction. On a 10 mm chamfer it's about 0.35 mm. Same callout, very different part.
The video's fix is to delete the ± angle, box the 60° as a basic dimension, and add an angularity frame with a datum. The tolerance zone is now a uniform band, and you can make it small where the fit needs it.
Where Angularity Stops
Angularity only controls orientation. GD&T Basics puts it plainly: it "CANNOT control the location of any feature." The face can be tilted correctly and still sit too high. If the face also needs to be in the right place, profile of a surface locates and orients it, with angularity added as a refinement only if needed.
It always needs a datum, so the datum choice is part of the callout. Choosing datums covers that, and parallelism, covered in flatness vs parallelism, is the same orientation control at 0°.
What We'd Do on Your Part
On our CNC work, untoleranced angles fall under ISO 2768-m, and tighter tolerances show up as a price uplift in the quote. If you need angularity measured and reported on specific faces, ask us when you quote.
Need a part made?
Upload your file for an instant price.